Disassembly Of The Set - Sharp VL-E610S Service Manual

3. DISASSEMBLY OF THE SET

3-1. Removal of the camera section
Note:
Before removing the cabinet, turn off the power supply, and ascertain that the battery has been removed.
1. Remove one screw ((d)XiPSF20P04000), one screw ((b)LX-HZ0018TAFF), two screws ((a)LX-HZ0018TAFN), and pull
out the camera front cabinet (1).
(b)
(d)
2. Remove the connector (1 pc.).
3. Remove one screw ((b)LX-HZ0018TAFF), one screw ((d)XiPSF20P04000) and two screws ((a)LX-HZ0018TAFN) and
pull out the camera rear cabinet (2) backwards.
(b)
(d)
4. Firstly, remove the CCD connector from the Camera PWB, then remove one screw ((c)LX-HZ0045TAFN), the reverse
side in this figure (Not remove the lens holder in this section).
(1)
Camera front cabinet
Tilt frame C
Connector
Pull out
* Remove the Camera rear cabinet, after removing the
connector.
Note:
When assembling the camera rear cabinet, lay the FPC
between the camera shield case and the tilt frame C, and
insert it into the connector.
(2)
Camera rear cabinet
(c)
CCD connector
3-1
VL-E610S/VL-E610H
VL-E660S/VL-E96E
VL-E98E
(a)
(a)
Pull out
(a)
(a)