Disassembly Of The Set; Procedure For Disassembling The Cabinet - Sharp VL-Z400H-T Service Manual

VL-Z400S-T/H-T
VL-Z500S-S/H-S/E-T/E-S

3. DISASSEMBLY OF THE SET

3-1. Procedure for disassembling the cabinet

Note: Before removing the cabinet, turn OFF the power and make sure that the battery is not connected.
1.
· Remove the screw ((s) XiPSF14P06000).
· Open the LCD panel 90 degrees and remove the two screws ((x) LX-
HZ0050TAFN).
· Remove the two screws ((c) XiPSN17P04000) and remove the
camera front cover by pulling it frontward.
2.
· Disconnect the connector of the camera front cover.
· Disconnect the two LCD tilt FPCs of the LCD panel.
· Remove the two screws ((r) XiPSN20P08000) and remove the LCD
panel.
· Remove the screw ((p) LX-HZ0063TAFN) and screw ((q)
XiPSN17P06000) that hold the camera L cabinet, open the terminal
cover and remove the three screws ((b) XiPSN17P03000).
3.
· Disconnect the FPC and remove the camera L cabinet.
· Remove the screw ((c) XiPSN17P04000) and remove the camera
bottom cover.
· VL-Z400: Remove the tilt angle and remove the two screws ((a)
XiPSN17P02000).
VL-Z500: Disconnect the INNER LED FPC, remove the two screws
((a) XiPSN17P02000) and remove the INNER LED unit.
Camera front cover
Camera front cover
VL-Z400
a
a
a
INNER LED unit
Tilt angle
VL-Z400
4
LCD panel
s
c
Camera front cover
r
r
LCD tilt FPC
b
Connector
INNER LED Unit
(VL-Z500 only)
VL-Z500
FPC
a
INNER LED
FPC
VL-Z500
x
x
c
LCD panel
p q
b
Camera L cabinet
Terminal cover
b
Camera L cabinet
Camera
bottom cover
c