VL-Z100S-S/H-S/E-S
VL-Z300S-S/H-S/E-S
3. DISASSEMBLY OF THE SET
3-1. Procedure for disassembling the cabinet
Note: Before removing the cabinet, turn OFF the power and make sure that the battery is not connected.
1.
· Remove the screw ((s) XiPSF14P06000).
· Open the LCD panel 90 degrees and remove the two screws ((x) LX-
HZ0050TAFN).
· Remove the two screws ((c) XiPSN17P04000) and remove the
camera front cover by pulling it frontward.
2.
· Disconnect the connector of the camera front cover.
· Disconnect the two LCD tilt FPCs of the LCD panel.
· Remove the two screws ((r) XiPSN20P08000) and remove the LCD
panel.
· Remove the screw ((p) LX-HZ0063TAFN) and screw ((q)
XiPSN17P06000) that hold the camera L cabinet, open the terminal
cover and remove the three screws ((b) XiPSN17P03000).
3.
· Remove the FPC and remove the camera L cabinet.
· Remove the screw ((c) XiPSN17P04000) and remove the camera
bottom cover.
· Remove the two screws ((a) XiPSN17P02000) and remove the tilt
angle.
LCD panel
s
c
r
b
LCD tilt FPC
Camera front cover
FPC
a
a
Tilt Angle
4
x
x
c
Camera front cover
r
LCD panel
q
p
Camera L cabinet
b
Terminal cover
b
Connector
Camera L cabinet
camera
bottom cover
c