Sharp VL-E610S Service Manual page 29

4-5-3. Actuating the mechanism with the cassette control ass'y removed
(1) Turn on the power supply with the cabinet and camera unit removed, referring to the Service Manual (so as to actuate
the mechanism).
(2) Put the cap (2) on the light guide (1).
(3) Press the cassette control down switch (5) through the adhesive tape (4) in the arrow direction so as to turn it on.
At this time take care to avoid contact with the cassette. Keep the switch pressed (if the switch is turned off, unloading
occurs).
Note: To set the Rec mode, press the pin (marked with the asterisk *) of recognition switch (3) (this operation is not
necessary in other modes).
Cassette control down switch (5)
4-5-4. Drum and Drum base
Removal
* To replace the upper drum, be sure to put on gloves. Due care is required so that the drum is not damaged.
(1) Drum base
Remove the 3 mounting screws as shown in Figure 1, and remove the drum base.
Adhesive tape (4)
Mounting screw
Drum base
Upper/lower drum ass'y
Figure 1
Cap (2)
Light guide (1)
Recognition switch (3)
*
Earth spring
Positioning
hole
4-15
VL-E610S/VL-E610H
VL-E660S/VL-E96E
VL-E98E