Sharp VL-E610S Service Manual page 10

VL-E610S/VL-E610H
VL-E660S/VL-E96E
VL-E98E
5. Disassembly of the LCD holder
(1)Remove two screws ((d)XiPSF20P04000), pull out the tripod angle.
(2)Remove the remote control ray reception PWB from the LCD, (Distorting the claw (snap-fit type) of the LCD holder,
release its engagement.)
(3)Remove two screws ((b)LX-HZ0018TAFF) and two connectors, and remove the LCD unit (with inverter) from the main
body.
(4)Disconnect the connector which connects the Li/RC unit to the main PWB, and slide the Li/RC unit in the arrow direction
from the frame V.
Note:
When connecting the FPC, pass it through the inside of rib of frame V (to prevent the FPC from being jammed).
Remote control ray reception PWB
Frame V rib
(d)
Claw
Claw
LCD unit
Connector
3-6
Tripod angle
Remote control ray reception section
(b)
Inverter transformer
Connector
Li/RC unit
Main PWB