Toshiba Vm Series Instruction Manual page 9

Introduction
This manual describes the functions, methods of wiring and setting, and maintenance and
inspection of the TC-net 100 extended I/F module ("TNB" hereafter) for connecting the
information/control network TC-net 100 to the controller of Unified Controller Vm series.
To use this device correctly, read "Safety precautions" first.
After reading this manual, keep it in a safe place so that you can read it wherever necessary.
The manuals related to the TNB module are as follows.
 Unified Controller Vm series Controller typeS Instruction Manual
Describes the main unit connection, maintenance of the typeS controller.
 Unified Controller Vm series Controller typeS PLC CPU Function Manual
Describes the functions and basic use of the typeS PLC CPU.
 Unified Controller /Integrated Controller Command Manual
Describes the detailed specifications of the instruction words of the
program languages (LD, FBD, and SFC) supported by the Unified
Controller and Integrated Controller.
 Unified Controller /Integrated Controller Engineering Tool 4 Operation
Manual -Basic-
Describes how to create, debug, print, and save programs with using nV-
Tool.
 Unified Controller /Integrated Controller Engineering Tool 4 Operation
Manual -Setup-
Describes how to set up nV-Tool.
 Unified Controller Vm series TC-net 100 extended module TNB Instruction
Manual(This document)
Describes the TC-net 100 interface extended I/F module of Vm series
controller.
Unified Controller Vm series TC-net (TNB) Module Instruction Manual
(6F8C1652)
(6F8C1645)
(6F8C1226)
(6F8C1290)
(6F8C1291)
(6F8C1637)
vii