Configuration Of The Main Pcb - Electrolux NEAT Service Manual

A standard main PCB is available as a spare part. This PCB contains only data relative to the wash cycle.
After replacing the main PCB, it is necessary to perform the configuration procedure in order to
operate the washing machine.
Configuration of the board consists of entering a 16-digit code which contains information which varies from
model to model (type of washing system, type of tub, spin speed, etc.).
To access the machine configuration procedure, first enter the diagnostics system, and then:
press the FABRICS or TEMPERATURE
buttons until LED L10 lights; the code
relative to the first of the 16 digits of the
configuration code (position 0) is
displayed.
when the SKIP/RESET button is
pressed, all the digits which make up the
configuration code are displayed in
sequence.
press the START/PAUSE button to
modify the configuration code (digit by
digit).
when all 16 digits have been entered,
check that the code is correct, then
memorize the code by pressing the
START/PAUSE and SKIP/RESET
buttons at the same time; these buttons
should be held down for at least 4
seconds (i.e. until the buzzer sounds).
When configuration has been completed, perform the diagnostics routine in order to check that the
appliance functions correctly. In case of an error, the display window will show error code E93 and
the machine stops.
TSE-P 04.00 EB

CONFIGURATION OF THE MAIN PCB

44/50 599 34 22-16