Diagnostics Cycle - Electrolux NEAT Service Manual

DIAGNOSTICS CYCLE

When the FABRICS or TEMPERATURE buttons are
pressed, the system passes to the previous or
subsequent phase of the diagnostics cycle. The LED
corresponding to the phase of the diagnostics cycle lights.
LED Function
lit tested
L1 Water fill to wash
compartment
L2 Water fill to prewash
compartment
L3 Water fill to softener
compartment
L4 Hot water fill or fill to
bleach compartment
(certain models only)
L5 Heating and
recirculation
L6
Check for leaks from
tub
L7 Drain and spin, check
for pressure switch
congruency
If an alarm condition occurs during the diagnostics cycle, operation of the appliance is interrupted, and the
LEDs (and display) show the corresponding alarm code (flashing).
TSE-P 04.00 EB
Components
actioned
- door interlock
- wash solenoid
- door interlock
- pre-wash solenoid
- door interlock
- pre-wash solenoid
- wash solenoid
- door interlock
- hot water or bleach
solenoid
- door interlock
- (wash solenoid if level is
lower than the anti-boiling
device)
- recirculation pump
- heating element
- door interlock
- (wash solenoid if level is
<150mm)
- motor
- door interlock
- drain pump
- motor
36/50
Operating
conditions
Door closed, water fill to
anti-overflow level for
max. 10 min
Door closed, water fill to
anti-overflow level for
max. 10 min
Door closed, water fill to
anti-overflow level for
max. 10 min
Door closed, water fill to
anti-overflow level for
max. 10 min
Door closed, water fill to
above anti-boiling level if
not yet reached, heating
for max. 10 min or to
90°C
Door closed, water fill
above 150mm level if not
yet reached, motor until
the drum reaches 250
rpm
Door closed, water drain,
motor movement (from
lower level to anti-foam
level), until maximum spin
speed is reached
Parameters
displayed
Water level in mm
Water level in mm
Water level in mm
Water level in mm
Water
temperature in °C
Motor speed
(rpm)
Motor speed
(rpm ÷ 10)
599 34 22-16