Network Configuration - Intellinet UNC-W10 User Manual

WIRELESS NETWORK IP CAMERA User's Guide

Network Configuration

This screen defines the network type and addresses of the Wireless Network IP Camera. Here you
can configure the Camera's IP address, the DNS server address, and the Server IP address. Each
configuration takes just a few seconds for booting after pressing "Submit".
1. Set IP Address, Subnet mask, gateway address.
To set the IP address, Subnet mask, and gateway address manually, you may select "manually" in
combo box.
In case of selecting "manually", you can configure them with the IP installer as well as this page.
(If you have trouble configuring network system information, please ask your network
administrator.)
To set DHCP, you may select 'using DHCP'.
When selecting "using DHCP", the IP address, Subnet mask address and Gateway address may not
be activated at all. Under DHCP selection, the IP address may be sent to an email address whenever
IP address is changed. Users in a local network area may check the IP address through IP installer.
35