Table of Contents
Advertisement
11.20 Engineer NVM Reset
Enter
This function, if enabled in system options 3, resets the panel to factory defaults. The NVM link
must be shorted before this will work.
11.21 Follow Select
Enter
This function is used in conjunction with Programmable Output 1 and 2, option 5 'Follow Zone'.
Enter the zone to be followed.
-
for zones 1 to 8 or
Enter
if no zone is to be followed.
11.22
Exiting Engineer Mode
Enter
NOTE: Refer to the User Manual for detailed instructions on how to use the Atlas 8 after programming.
Rins171 Issue 6
(Where
is the 4 digit Engineer Code).
Page 27
Advertisement
Table of Contents
Need help?
Do you have a question about the ATLAS 8 and is the answer not in the manual?
Questions and answers