Engineer Code Nvm Reset (Function 751); Programmable Outputs Test (Function 752); Walk Test (Function 753); Scan For Devices On The Bus (Function 754) - Pyronix Matrix 424 Programming Manual

16.2 Engineer Code NVM Reset (Function 751)

Press .
An acceptance or low error tone indicates whether the function succeeded or failed. This usually takes a
number of seconds to complete.
On completion of the function (pass or failure) you will be returned to Engineer Mode.

16.3 Programmable Outputs Test (Function 752)

Press .
Enter the PGM output you want to test as a 2-
digit number (01 – 12)
Press to toggle the PGM output.
Repeat for further outputs as needed.
Press to exit the function.

16.4 Walk Test (Function 753)

Press .
Enter 1 digit for the Arm Mode (1 = A ... 4 = D)
Open / close the zones you wish to test.
Repeat for other zones as needed.
Press to exit the function.

16.5 Scan for Devices on the Bus (Function 754)

Press .
A progress counter appears.
It counts up in tens (1-8) and units (1-4 & 1-2)
until 82 is reached.
At the end of the scan all devices are reset.
NOTE: When this function is run from the
Engineer Menu, some of the messages may
be difference from those shown here.
You are automatically returned to Engineer Mode.
16.6 Local Up/Downloading – RS232 (Function 755)
Press .
The display will remain until either completed your UDL session or no connection was made within 30
seconds.
RINS916-6
Matrix 424/832/832+ LCD Programming Manual
This starts the function
This starts the function
Example shows PGM 1
The original state of the
outputs will be restored
This starts the function
Example shows Arm
Mode A selected
Example shows Zone 1
This starts the function
Example shows Arm
Mode A selected
This starts the function
NVM RESET
SYSTEM BUSY
PGM TO TEST ?
__
PGM TO TEST ?
01
PRESS A,B,C OR D
WALK TEST
ARM MODE A
WALK TEST
ZONE 1
SCAN FOR DEVICES
01
ENGINEER MODE
01
ENGINEERS MODE ENGINEERS MODE ENGINEERS MODE ENGINEERS MODE ENGINEERS MODE ENGINEERS MODE ENGINEERS MODE ENGINEERS MODE ENGINEERS MODE ENGINEERS MODE ENGINEERS MODE ENGINEERS MODE ENGINEERS MODE ENGINEERS MODE ENGINEERS MODE ENGINEERS MODE ENGINEERS MODE ENGINEERS MODE ENGINEERS MODE ENGINEERS MODE ENGINEERS MODE ENGINEERS MODE ENGINEERS MODE ENGINEERS MODE ENGINEERS MODE ENGINEERS MODE ENGINEERS MODE ENGINEERS MODE ENGINEERS MODE ENGINEERS MODE ENGINEERS MODE ENGINEERS MODE ENGINEERS MODE ENGINEERS MODE
82 82 82 82 82 82 82 82 82 82 82 82 82 82 82 82 82 82 82 82 82 82 82 82 82 82 82 82 82 82 82 82 82 82
RS232 UDL ENABLE
SYSTEM BUSY
Page 55