Troubleshooting - Husqvarna R112iC Operator's Manual

2. Lock the blade with a wooden block.
3. Loosen and remove the blade bolt (A), the washers
(B) the blade (C) and the blade support (D).
Troubleshooting schedule
If you cannot find a solution to your problems in this
operator's manual, speak to your Husqvarna service
agent.
Problem
The first and fourth battery LED
light and the warning indicator on
the display flashes.
The warning indicator on the dis-
play has a solid red light.
The warning indicator on the dis-
play flashes red + blades engag-
ed indicator.
24
A
B
C
D

Troubleshooting

Cause
The battery is damaged.
Temperature deviation, the bat-
tery is too cold or too hot.
A fault is found in the product.
The cutting deck has stopped be-
cause of high load.
A fault is found in the control
units on the cutting deck.
4. Install in the opposite sequence. Install the new
blade with the bent ends in the direction of the
cutting deck.
WARNING:
can cause objects to eject from the
cutting deck and cause serious injury.
Use only the blades given in
data on page 29 .
Action
Speak to an approved service workshop.
Let the battery become cool down or move
the product to a location with the approved
temperature for the batteries. Refer to
age on page 28 .
Stop the product for minimum 5 seconds and
then start the product again.
Speak to an approved service workshop if
the warning indicator has a solid red light
after restart.
Stop the product and wait for the motor to
cool down before you restart.
Speak to an approved service workshop if
the warning indicator flashes after restart.
Incorrect blade type
Technical
Stor-
1263 - 005 - 03.02.2022