Maintenance - Husqvarna R112iC Operator's Manual

4. Carefully push down 1 pedal. Use pedal (A) to move
forward, and pedal (B) to move in reverse. The
speed increases the more the pedal is pushed down.
5. Release the pedal to engage the brakes.
6. Lower the cutting deck.
To start and stop the SavE function
The product has a battery save function (SavE)
that gives longer operation time. The SavE function
Introduction
WARNING:
safety chapter before you do maintenance
on the product.
Maintenance schedule
* = General maintenance done by the operator. The
instructions are not given in this operator's manual.

Maintenance

Make sure all fasteners are properly tensioned (screws, nuts etc).
To clean the product on page 21 .
Clean as given in
Clean the inner surface of the cutting deck, around the blades.
Make sure that the safety devices are not defective.
20
A
B
Maintenance
Read and understand the
decreases the speed of the product and the speed of
the blades.
1. Long press the SavE button.
Note:
The SavE indicator comes on with a
constant green light when the function is started.
2. Long press the SavE button again to stop the SavE
function.
To stop the product
1. Park the product on level ground.
2. Apply the parking brake.
3. Pull the lift lever for the cutting deck rearward to lift
the cutting deck to transport position.
4. Set the power switch to "0".
To get a good result
• Do not cut a wet lawn. Wet grass can give a bad
result.
• Start with a high cutting height and decrease it
gradually.
• Cut with blades that rotate at high speed (for highest
permitted motor speed, refer to
page 29 ). Move the product forward at low speed.
If the grass is not too high and thick, you can get a
good result also at a higher speed.
• To get the best result, cut the grass frequently and
use the mulch function. Refer to
mulch plug on page 23 .
X = The instructions are given in this operator's manual.
O = The instructions are not given in this operator's
manual. Let an approved service agent do the
maintenance.
Note:
If more than one time interval is identified
in the table, the shortest time interval is for the first
maintenance only.
Technical data on
To remove the
Maintenance
interval
Daily mainte-
nance before
50 hours or
operation
one time each
year
*
X
X
X
1263 - 005 - 03.02.2022