Transportation, Storage And Disposal - Husqvarna R112iC Operator's Manual

Display LED light signals
The LED lights on the display will give signals if there
is a fault or if the operation conditions are not obeyed.
To do a check of the operation conditions on
Refer to
page 13 .
1
4
Mode Signal
Drive mode The operator
presence control
LED light (4)
flashes 5 times.
Transportation
• The product is heavy and can cause crush injuries.
Be careful when you load it onto or off a vehicle or
trailer.
• Use an approved trailer for transportation of the
product.
• Make sure that you have knowledge of local
road traffic regulations before transportation of the
product in a trailer or on roads.
To tow the product
1. Put the lift lever to the cutting deck in transport
position.
2. Disengage the parking brake.
3. Tow the product short distances only and at low
speed.
1263 - 005 - 03.02.2022
2 3
5
6
Situation
The operator left
the seat when the
product is used.

Transportation, storage and disposal

Mode Signal
Standby mode The operator
presence control
LED light (4)
flashes.
The battery LED
lights (5) 1–4
flashes.
The parking brake
indicator LED
light (1) flashes.
The blades en-
gaged indicator
LED light (2)
flashes.
The standby indi-
cator (3) and the
warning indicator
(6) flashes until
the start button is
released.
The parking brake
is engaged and
the standby indi-
cator (3) and the
warning indicator
(6) flashes until
the start button is
released.
To safely attach the product on a trailer for
transport
WARNING:
not sufficient to lock the product during
transport. Attach the product tightly to the
trailer.
Equipment: 2 approved tension belts and 4 wedge
shaped wheel blocks.
1. Apply the parking brake.
2. Attach the tension belts around the frame or rear
wagon.
3. Tighten the tension belts in the direction of the rear
and the front of the trailer to secure the product.
4. Put the wheel blocks in front of and behind the rear
wheels.
Situation
The start button
is pushed when
there is no opera-
tor in the seat.
The start button
is pushed when
the charger is
connected.
The start button
is pushed but the
parking brake is
not applied.
The start button
is pushed when
the cutting deck is
lowered.
The start button
is pushed when
the forward or
rearward pedal is
pushed down.
Speak to an ap-
proved service
workshop.
The parking brake is
27