EDELRIDe 88492 Instruction Manual page 13

Users must be aware that poor physical and mental health can
jeopardise safety under normal conditions and in emergencies.
Before using the equipment, users must familiarise themselves
with safe and effective rescue procedures.
The manufacturer cannot be held liable if the equipment has
been abused or used incorrectly.
All risks and responsibilities are borne by the user at all times.
When using this product in the areas of rescuing and personal
protective equipment, we recommend that the relevant nation-
al regulations be observed.
PRODUCT-SPECIFIC INFORMATION
Specification
This product meets obligatory requirements of EN 397, except
for the retention system.
The retention system has a strength of at least 50 daN, and
elongation of the whole system is not longer than 25 mm (re-
quirement of EN 12492).
Additionally the product meets optional requirements of EN
397: Protection against impact under low temperature -30°C.
This product meets obligatory requirements of ANSI/ISEA
Z89.1-2014 Type I Class G.
Fitting
To provide safe protection, this helmet must be adapted to the
head size of the user. The safety helmet must be adjusted to
head size in such a way so that it cannot shift or slip off when
the chin strap has been tightened. This is the only way to ensure
protection from the helmet. The helmet is only secure when the
chinstrap is closed, the straps are pulled taught, and adjust-
ments have been made to fit individual head size. The straps
may not cover the ears and the closure may not rest on the
chin. No pressure should be exerted on the larynx when the
chinstrap is closed. The helmet should always be horizontal on
the user's head in order to also protect the forehead.
5XXXX-493_GAL_Helme_Serius HeightWork_JD_20170713.indd 13
Fig. 1
Nomenclature of parts
(1) Shell, (2) Position adjuster, (3) Chin strap buckle, (4) Head-
lamp clip, (5) Adjustable wheel (6) Head fitting adjustment
Fig. 2
Storage of headbelt adjustment system.
Fig. 3
Places for additional marking and/or stickers.
Fig. 4
Euroslot 30 mm for additional accessories (Ears and face pro-
tection).
Fig. 5
Correct buckle opening.
Fig. 6
Head fitting adjustment.
Fig. 7
Buckle and position adjuster for correct and comfortable posi-
tion around the ears.
Fig. 8
Webbing length adjustment for correct and comfortable posi-
tion around the ears.
GENERAL INFORMATION ON SAFETY, PRODUCT LIFE,
STORAGE, CARE AND IDENTIFICATION
Safety notices
If original components are modified or removed from the prod-
uct, its safety aspects may be restricted. The equipment should
not be modified in any way or altered to allow attachment of
additional parts without the manufacturer's written recommen-
dation.
Paint, solvents, adhesives or self-adhering stickers may only be
applied in keeping with the manufacturer's instructions. The
equipment must be checked for possible damage before and
after each use. It must be ensured that the equipment is ser-
30.08.2017 09:56:17