Restored To Factory Setting (System Reset) - ITech IT-M3900D Series User Manual

5.14 Restored to Factory Setting (System Reset)

This menu item is used to restore some parameter settings to factory setting
values.
The procedures to set the menu item are as follows.
1. Press the composite keys [Shift]+[P-set] (System) on the front panel to en-
2. Turn the knob to select the System Reset and press [Enter].
3. Press the Left / Right key or turn the knob to adjust the value of this
4. After the parameter settings are complete, press [Enter].
Current Limit
Run Time
ter the system menu.
parameter.
•
No: Default value, indicates the instrument cancels this menu setting.
•
Yes: Indicates the instrument restores the factory default settings.
The parameters affected by System Reset and the parameter values after
reset are shown in the following table.
Table 5–2 Initial value of the parameter
Parameter
Category
Main Voltage setting: Vset
interface
Current setting: Iset
Upper limit of voltage: Vlim
Upper limit of current: Ilim
Upper limit of power: Plim
[On/Off] status
Copyright © Itech Electronic Co., Ltd.
Display the maximum current limit.
Display the power-on time.
Basic Operation
Initial Value
0.002V
One percent of the rated
current of the instrument
Upper limit value:
0.002V
One percent of the rated
current of the instrument
Rated power value of
the instrument
Off
158