J101 Connector (Model 340 Telemetry System Interface) - GE Corometrics 250 Series Service Manual

J101 Connector (Model 340 Telemetry System Interface)

NOTE: For additional information,
refer to the Model 340 Service Manual,
P/N 2006920-001.
J102 Connector (Spectra 400 Analog Interface)
J103 Connector (Model 2116B Data Entry Interface)
3-4
Installation: Connections
This connector is for future interfacing to the receiver of a Corometrics Model 340
Telemetry System.
A telemetry indicator is displayed beneath the FHR1 mode field:
you connect a telemetry receiver to the 250 Series Monitor; and
the receiver detects an active FECG, MECG, US, TOCO, or IUP mode from the
associated transmitter.
NOTE: The monitor, receiver, and transmitter must all be turned on.
NOTE: When any telemetry mode is detected (US, FECG, MECG, TOCO, or IUP), all
equivalent front panel modes (US, US2, FECG, MECG, TOCO, or IUP) are
ignored. You cannot "mix and match" telemetry and monitor modes.
The telemetry connected annotation
of the strip chart paper:
upon commencement of telemetry monitoring; and
every 30 minutes along with the modes.
The telemetry disconnected annotation
you unplug the telemetry receiver from the 250 Series Monitor;
you turn off the receiver;
you turn off the transmitter; or
the receiver does not detect any active mode information from the transmitter.
This Centronics-type connector is designed for interfacing to a Corometrics Spectra
400 Central Surveillance and Alert System or other compatible analog central
information system. This connector is often referred to as the Analog Interface
Connector. For detailed information about connecting to a Spectra 400 System, refer
to the "Systems Pre-Installation Manual" (P/N 1279AA).
This connector is specifically designed for connecting to an optional Corometrics
Model 2116B Data-Entry/Clinical-Notes Keyboard. For detailed information about
connecting the Model 2116B to the monitor, refer to the "Model 2116B Product
Manual" (P/N 1252BA).
250 Series Maternal/Fetal Monitor
2020551-001
is printed on the bottom line of the top grid
is printed on the strip chart paper if:
Revision D