Optional Communication Package; J101 Connector (Model 340 Telemetry System Interface); J102 Connector (Spectra 400 Analog Interface); J103 Connector (Model 2116B Data Entry Interface) - GE Corometrics 126 Service Manual

Optional Communication Package

J101 Connector (Model 340 Telemetry System Interface)

J102 Connector (Spectra 400 Analog Interface)

J103 Connector (Model 2116B Data Entry Interface)

11-18
Peripheral Devices: Optional Communication Package
The communication option is an additional circuit board that can be installed in the
120 Series Monitor. Contact your GE Service Representative for upgrade
information.
This connector is for future interfacing to the receiver of a Corometrics Model 340
Telemetry System.
A telemetry indicator
screen if:
you connect a telemetry receiver to the 120 Series Monitor; and
the receiver detects an active FECG, MECG, US, TOCO, or IUP mode from the
associated transmitter.
NOTE: The monitor, receiver, and transmitter must all be turned on.
NOTE: When any telemetry mode is detected (US, FECG, MECG, TOCO, or IUP),
all equivalent front panel modes (US, US2, FECG, MECG, TOCO, or IUP)
are ignored. You cannot "mix and match" telemetry and monitor modes.
The telemetry connected annotation
of the strip chart paper:
upon commencement of telemetry monitoring; and
every 30 minutes along with the modes.
The telemetry disconnected annotation
you unplug the telemetry receiver from the 120 Series Monitor;
you turn off the receiver;
you turn off the transmitter; or
the receiver does not detect any active mode information from the transmitter.
This connector is designed for interfacing to a Corometrics Spectra 400 Central
Surveillance and Alert System or other compatible analog central information
system. For detailed information about connecting to a Spectra 400 System, refer to
the "Systems Pre-Installation Manual"
This connector is specifically designed for connecting to an optional Corometrics
Model 2116B Data-Entry/Clinical-Notes Keyboard. For detailed information about
connecting the Model 2116B to the monitor, refer to the
Manual" (P/N 1252BA).
120 Series Maternal/Fetal Monitor
2015590-001
is displayed (see Figure 5) in the top left corner of the
is printed on the bottom line of the top grid
is printed on the strip chart paper if:
(P/N 1279AA).
"Model 2116B Product
Revision B