Page 3
Understanding Mounting and Installer’ s Choice® Hunter’s patented 2-position mounting system provides you maximum installation flexibility and ease. You can install your Hunter fan in one of two ways, depending on ceiling height and your preference: Standard or Angled mounting. The steps in this manual include instructions for both Installer’s Choice mounting methods.
• Drill holes for and install wood screws. • Identify and connect electrical wires. • Lift 40 pounds. If you need help installing the fan, your Hunter fan dealer can direct you to a licensed installer or electrician. Gathering the Tools You will need the following tools for installing the fan: •...
Tighten the screws into the 9/64” pilot holes; do not use lubricants on the screws. Do not over tighten. 3” Screw 45043-01 • 10/19/09 • Hunter Fan Company Flat Washer Ceiling Peak Large Opening...
3-1. Unbundle the wires from the fan. 3-2. To assemble fan to hang down from a flat or angled ceiling, insert the downrod through the canopy, canopy trim ring, and upper glass. Feed the wires from the fan through the downrod.
4-7. Spread the wires apart, with the grounded wires on one side of the outlet box and the ungrounded wires on the other side of the outlet box. 45043-01 • 10/19/09 • Hunter Fan Company 4 •Wiring the Fan Wire...
Should you need to remove the canopy trim ring, follow these steps: 1. Twist canopy trim ring counter clockwise until it releases from canopy. Step 5-5 45043-01 • 10/19/09 • Hunter Fan Company Steps 5-1 – 5-2 Canopy Step 5-4 Canopy Screw...
Hunter fans use several styles of fan blade irons (brackets that hold the blade to the fan). 6-1. Your fan may include blade grommets. If your fan has grommets, insert them by hand into the holes on the blades. 6-2. Attach each blade to a blade iron using three blade assembly screws.
7 • Completing Your Installation With a Bowl Light Fixture Your Hunter fan comes with an integrated light fixture assembly. WARNING: Use only the light fixture supplied with this fan model. 7-1. To attach the upper switch housing, partially install two housing assembly screws into the switch housing mounting plate.
190 Watts. Exceeding that limit or the marked limit on this product may result in fire hazard or improper operation. 45043-01 • 10/19/09 • Hunter Fan Company Steps 7-5 – 7-6 Lower Switch Housing...
Page 12
7-13. Thread the light pull chain through the finial and screw the finial onto the threaded rod end until tight. Breakaway Connector 45043-01 • 10/19/09 • Hunter Fan Company Light Bulbs (B10 Candelabra Base 40 Watt Maximum)
Page 13
7 • Completing Your Installation With a Light Fixture (Continued) 7-14. Install (4) B10 candelabra bulbs into the sockets. Light Bulbs (B10 Candelabra Base 25 Watt Maximum) 45043-01 • 10/19/09 • Hunter Fan Company...
8 • Operating and Cleaning Your Ceiling Fan 8-1. Turn on electrical power to the fan. 8-2. The fan pull chain controls power to the fan. The pull chain has four settings in sequence: High, Medium, Low, and Off. • Pull the chain slowly to change settings.
1. Turn the power to the fan off at the wall switch. Wait 30 seconds, then resume power to the fan. 45043-01 • 10/19/09 • Hunter Fan Company 9 • Troubleshooting If you need parts or service assistance, please call...