Page 2
90% Pre-Assembled Out Of The Box! Makes Installation Fast & Easy 1. Install mounting bracket and make wiring connections 2. Attach EasyLock Blades Installation is complete! Please follow the detailed installation instructions inside this manual 45051-01 • 05/12/11 • Hunter Fan Company...
Page 4
• No object can come in contact with the rotating fan blades during normal operation. • The fan blades are at least 7 feet above the floor and the ceiling is at least 8 feet high. • The fan blades have no obstructions to airflow, such as walls or posts, within 30 inches of the fan blade tips.
Page 5
3-1. Attach a 2” x 4” support brace between two joists. Position it to allow you to recess the bottom of the outlet box a minimum of 1/16” into the ceiling. 3-2. Check the support brace to ensure it will support the full weight of the fan and light kit.
Page 6
Understanding Mounting and Installer’ s Choice® Hunter’s patented 2-position mounting system provides you maximum installation flexibility and ease. You can install your Hunter fan in one of two ways, depending on ceiling height and preference: Standard or Angled mounting. The steps in this manual include instructions for all three Installer’s Choice mounting methods.
• Drill holes for and install wood screws. • Identify and connect electrical wires. • Lift 40 pounds. If you need help installing the fan, your Hunter fan dealer can direct you to a licensed installer or electrician. Gathering the Tools You will need the following tools for installing the fan: •...
For proper alignment use slotted holes directly across from each other. If you are installing the fan on an ANGLED ceiling, be sure to orient the hanger bracket as shown in Illustration 2-3 (left or right view).
3 • Assembling and Hanging the Fan 3-1. To assemble fan to hang down from a flat or angled ceiling, place the canopy and canopy trim ring around the adapter so that they rest on the fan assembly. 3-2. Feed the wires from the fan through the downrod.
4-6. Turn the wire connectors upward and push them carefully back through the ceiling plate into the outlet box. 4-7. Spread the wires apart, with the grounded wires on one side of the outlet box and the ungrounded wires on the other side of the outlet box.
Should you need to remove the canopy trim ring, follow these steps: 1. Twist canopy trim ring counterclockwise until it releases from canopy. Step 5-5 45051-01 • 05/12/11 • Hunter Fan Company Steps 5-1 – 5-2 Canopy Step 5-4 Canopy Screw...
6-3. Close the locking mechanism securely. You will feel it lock into place. 6-4. Repeat steps 6-1 through 6-3 until all blades are installed. Note: You can customize your Hunter fan with a number of accessory light kits. 45051-01 • 05/12/11 • Hunter Fan Company 6 •...
7 • Operating and Cleaning Your Ceiling Fan 7-1. Turn on electrical power to the fan. 7-2. The fan pull chain controls power to the fan. The pull chain has four settings in sequence: High, Medium, Low and Off. • Pull the chain slowly to change settings.
2. Check to see if the blade is cracked. If so, replace all the blades. Problem: Excessive wobbling. 1. If your fan wobbles when operating, use the enclosed balancing kit and instructions to balance the fan. 2. Tighten all blade iron screws.