PEAK COMMUNICATIONS P7001R Installation And Operating Handbook page 29

Instruction 22 (Rx/Tx Reconfiguration Request):
The message body for this message is a truncated form of the Rx/Tx Status Request
Reply (instruction 21)
i.e. no information after the SHF Gain I/P power parameter is sent.
Not all parameters have to be set, if the user doesn't wish to change a particular
parameter then a number of 'x''s can be sent in the parameter's place. Sending such
data will ensure that the unit ignores that particular parameter.
'x''s should also be sent in place of parameters that are not used by the particular unit
type.
The unit MUST be in remote mode to allow reconfiguration of parameters via the
remote control. Setting the unit in Remote mode can be done either by the front panel
or remotely using the following command:
Page 29 P7001R & P7002R Series Converters