Installation; Care Of Your Product; Handling; Unpacking And Inspection - PEAK COMMUNICATIONS P7001R Installation And Operating Handbook

2. INSTALLATION

2.1 Care of Your Product

2.1.1 Handling

The shipping carton is qualified for transit of these products and has been used
successfully for many years. It will protect against shock and vibration encountered
during normal carrier transportation.
PLEASE RETAIN ALL PACKING MATERIALS, including the foam insets. Should the
unit need to be returned, return to the address on the front of the manual USING THE
ORIGINAL PACKING CARTON, unless it has been seriously damaged.
Avoid subjecting the packaged or unpackaged product to severe shocks.

2.1.2 Unpacking and Inspection

When the product is first received, the outer pack should be inspected for signs of
damage. If damage to the outer pack is evident, contact the Carrier immediately and
submit a damage report. The equipment should then be removed and inspected for
signs of damage, retaining all packing materials. Any visible signs of damage to the
equipment should be reported immediately to Peak Communications (electronic
photo's of the pack and equipment can help with any subsequent insurance claims). If
the equipment appears undamaged, it should be tested for correct operation and
again any abnormalities reported to Peak Communications.
When first removing the product from its transit pack, take care to retain all
documentation and associated hardware. These products are typically provided with
the following items;
 P700XR series product.
 Operation Manual.
 Test Results.
 Spares Kit.
If you suspect that any item is missing, please contact Peak Communications
immediately.

2.1.3 Storage

Store the product in the normal horizontal orientation, in its outer carton until it is
required for use. Do not use the products to support the weight of other items whilst in
storage.
Storage temperature range is typically from -40°C to +80°C, avoid exceeding these
extremes otherwise damage may result.
Avoid exposing the packaged or unpackaged product to extremes of humidity or
moisture (including condensation). In the event that this does occur, the product
should be left at room temperature for in excess of 5 hours to dry naturally before
application of prime power.

2.2 Mechanical Installation Considerations

Page 16 P7001R & P7002R Series Converters