Start Setup; Registering The Repeater - Yealink HORIZON W73P User Manual

Start Setup

Up to 6 repeaters can be registered to one base station to extend the range in a star layout. All
repeaters must be installed within the base station coverage, as shown in the figure below.
The maximum number of handsets that can be registered to your base station is not affected by
the repeater. The repeater can be used to extend the coverage range in all directions, allowing
several floors to be covered.

Registering the Repeater

If you want to register more than one repeater, in order to avoid ID conflict, we recommend that
you put the repeaters closer to the base station and register the repeaters one by one.
1. Plug the repeater into a power outlet. The Power LED will turn green and the DECT LED will
flash red.
Set the handset into RT30 Repeater Mode by going to "Settings→ System → Settings →
2.
Repeater Mode".
3. Set the base station in registration mode by long pressing the paging key on the base station
until the first LED flashes green.
4. If the base station is found, the DECT LED will flash orange.
When the DECT LED turns green/orange, the registration to the base station has been successful.
Horizon / Yealink W73P User Guide
22