Clamping The Outboard Motor - Yamaha E40X Owner's Manual

q
EMF14110

CLAMPING THE OUTBOARD MOTOR

Manual tilt model
1) Place the outboard on the transom so
409011
w
Loose clamp screws could allow the
motor to move on the transom or fall off
the transom. This could cause loss of
control and serious injury. Make sure the
transom screws are tightened securely.
Occasionally check the screws for tight-
ness during operation.
2) Secure the clamp bracket to the tran-
w
q
Avoid using bolts, nuts or washers other
than those contained in the engine pack-
409012
aging. If used, they must be of at least
the same quality of material and strength
and must be tightened securely. After
tightening, test run the engine and check
their tightness.
1 Motor mounting parts
3-4
that it is positioned as close to the
center as possible. Tighten the tran-
som clamp screws evenly and secure-
ly. Check the clamp-screws for tight-
ness occasionally during operation of
the motor as they can work loose due
to engine vibration.
som with the bolts provided with the
outboard. For details, consult your
dealer.
GB