Display Setup Sub-Menu - Honeywell SC1000 Owner's Manual

16.4.5
DISPLAY SETUP
Sub-Menu
Menu Item
DISPLAY. DIGITS
Menu Item
DISPLAY. DECPT
Menu Item
DISPLAY. COUNT-BY
Menu Item
DISPLAY. UNITS
Menu Item
DISPLAY. AVERAGE
This menu controls how data values are displayed by the channel and transmitted
via serial communications.
Selects the number of digits displayed by the channel. The choices are:
• " " displays both positive and negative numbers with five full dig-
5 DIGIT-BIPOLAR
its (±99999).
• " " displays positive numbers with six full digits (999999) and
6 DIGIT-UNIPLOAR
negative numbers with five full digits (-99999).
• " displays positive number with seven full digits (9999999)
7 DIGIT UNIPOLAR"
and negative numbers with six digits (-999999).
Selects the decimal point location on the channel's display and serial communica-
tions output. Use the [UP] and [DOWN] buttons to move the decimal point to the
right and left.
Determines by what value the display increments or decrements. This will make
the display less sensitive to a noisy signal. The choices are:
• " "
00001
• " "
00002
• " "
00005
• " "
00010
• " "
00020
• " "
00050
• " "
00100
• " "
00200
Specifies the four character label that is displayed to the right of the channel's val-
ues. This menu item doesn't change the mathematical scaling of the channel's
values; that is determined by the "
When a character position is flashing press the [UP] or [DOWN] button to change
the character. Press [ENTER] to advance to the next character.
Controls the speed with which the channel's display values will update. The
choices are:
• " " means that the display will update four times each second. The channel's
ON
values will be averaged for 1/4 second, then displayed.
• " " means that the channel's display will update as quickly as possible.
OFF
->
CALIBRATION DATA FULL SCALE VALUE
SC Series Instruction Manual
" menu item.
page 147