Setup Procedure - Honeywell SC1000 Owner's Manual

13.3 Setup Procedure

If you are not familiar with operating the instrument in the SETUP menu mode,
see "SETUP Menu mode" on page 23. A listing of all menu item is given in "Setup
Menu Reference" on page 157.
Step 1: Wire to the channel's connector.
See the "Wiring" section earlier in this chapter for details.
Step 2: Use the appropriate Limit Menu to setup the limits.
See "Limits" on page 53 for information about limits.
NOTICE
A SensoCode program running on a Mathematics Virtual Channel may over-
ride the default behavior of the relay outputs. Consult the Customer Information
Sheet included with your instrument for details.
SC Series Instruction Manual page 125