Fm Radio Mode; Select Stations; Now Playing Information; Scan Settings - Pinell SUPERSOUND 202 User Manual

FM radio mode

FM radio mode receives analogue radio from the FM band and displays RDS
(Radio Data System) information about the station and show (where broadcast).
To enter FM mode, either press SOURCE to choose FM Radio or select
MENU > Main Menu > FM.

Select stations

To find a station, press SELECT. The frequency display starts to run up as
Supersound 202 scans the FM band. Alternatively, you can scan up or down by
pressing and holding the TUNE+ or TUNE- buttons or tune manually with quick
presses, or by turning the SELECT control.
Presets to store an FM preset, press and hold PRESET until the display shows
the Save preset screen. Select one of the 20 presets to save the currently
playing station.
To select a preset, press PRESET briefly, then select one of the listed Preset
☆
stations. When a preset station is playing, it shows 1,2,3 etc in the bottom
middle of the screen.

Now playing information

While an FM station is playing, the screen shows one of the two following sets
data:
If RDS information is available, by default the service name (i.e. station
name) is displayed.
You can cycle through further RDS information by pressing INFO. Each time
you press INFO, another set of information is displayed, cycling through RDS
radio text, RDS program type, frequency and today's date.
If no RDS information is available, the currently tuned frequency is shown.

Scan settings

By default, FM scans stop at any available station. This may result in a poor
signal-to-noise ratio (hiss) from weak stations. To change the scan settings to
stop only at stations with good signal strength, select MENU > Scan setting >
Strong stations only? > Yes.
20