Auto-Update - Pinell SUPERSOUND 202 User Manual

Auto-update

Auto-update works with data sent over DAB, FM or the Internet. The clock is only
updated when in a corresponding mode, so it is best to select a mode you use
regularly.
DAB and FM use time signals broadcast with radio transmissions.
Network uses a time signal sent from the Internet radio portal when in any
network-connected mode.
1. Select Update from DAB, Update from FM, Update from Network or No
update.
2. If you are updating from the network, set your time zone.
3. If your country uses daylight saving, the automatically updated time from the
network may be wrong by one hour. When daylight savings are in in effect
(during the winter), turn on the Daylight savings option to rectify this.
Note that if you are updating the time from DAB or FM, the Daylight savings
option has no effect on the clock's time.
Supersound 202 will auto-update from the selected source when time
information is available.
Manual set
If you set No update, the wizard now prompts you to set the time and date
manually.
The date and time are displayed as dd-mm-yyyy and hh:mm with the first value,
dd, active (flashing).
Adjust each value with the SELECT control.
As each value is set, the next value becomes active and flashes
If the network is open (non-encrypted), Supersound 202 connects and no further
details are required; see Completion below.
10