Table of Contents
Advertisement
K3NC
3 OUTPUT OPERATION TIMING IN RUN MODE (RELAY AND TRANSISTOR OUTPUTS)
The K3NC can output the results of Up/Down counting as comparative outputs.
The output mode can be set to the ALL-H mode or the ALL-L mode.
ALL-H
If the ALL-H output mode is selected, outputs 1 to 5 will be
ON when the measured value exceeds set values 1 to 5.
Measured value
Set value 5
Set value 4
Set value 3
Set value 2
Set value 1
Reset
Compensation
value
Output 5
Output 4
Output 3
Output 2
Output 1
Note: Set value 2 < compensation value < set value 3
While the reset signal is ON, the counting value will return to zero.
When the compensation signal is ON, the K3NC will be in counting operation starting with the preset compensation value. Depending on
the setting conditions, the compensation value will be effective only for the incrementing operation.
3 OUTPUT DELAY (REFERENCE VALUE)
The following table shows the time required for a K3NC in a system to go into reverse output operation after the counting value reaches
the value preset with the K3NC, and is due to the output processing time of the K3NC, signal transmission time of the system, and the
relay connected to the K3NC.
Control I/O
Relay contact output
NPN/PNP transistor output
Reset input
Compensation input
Bank switch
Note: Output delay time varies with the operating environment. If the output delay time will possibly have a serious influence on your
system, check the actual output delay time before applying the K3NC to the system.
8
ALL-L
If the ALL-L output mode is selected, outputs 1 to 5 will be
ON when the measured value is less than set values 1 to 5.
Set value 5
Set value 4
Set value 3
See Note.
Set value 2
Set value 1
Reset
Compensation
value
Output 5
Output 4
Output 3
Output 2
Output 1
Note: Set value 2 < compensation value < set value 3
Output or response delay time
3.0 to 10.0 ms
0.1 to 0.6 ms
12.0 to 16.0 ms
12.0 to 16.0 ms
60.0 to 100.0 ms
Measured value
See Note.
K3NC
Advertisement
Table of Contents
