EdilKamin PELLKAMIN 8 EVO Manual page 16

The insert is supplied with a base plate (A) complete
with smoke duct (B) and primary air duct (C).
To fit, proceed as follows:
• Check for a power outlet on the back of the insert, so
that it is accessible once installation is complete.
• After evaluating the proper position of the insert, lift it
using the two handles on the sides of the insert (D),
from the base plate (A).
• Secure the base plate (A) on the base using
bolts through the holes positioned on the perimeter of
the plate (X – Fig. 4).
Alternatively, to secure the above plate, you can use
the existing holes in the same base plate (Y – Fig. 4)
and countersunk screws (the screw head must not
protrude more than 2 mm from the base plate).
The customer can make other holes, being careful not
to do so in line with the guides (Z – Fig. 4)
• Fit the flue (not supplied) on the smoke duct (B) and
the Ø 40 mm tube (C1 – not supplied) on the primary
air duct (C).
16
The Ø 40 mm tube (C1 – not supplied) can be installed
from below the base plate (A), see Fig. 3.
• Replace the insert (Fig. 4) by sliding it on the base
plate (A – Fig. 2) until it stops (the insert must fit in the
two slots (E – Fig. 2) in the front part of the base plate
(A – Fig. 2), taking care that the power supply cord is
not crushed between the two plates.
INDICATIVE DRAWINGS,
REFERRING TO THE SPECIFIC MODEL.
INSTALLATION
fig. 1
fig. 2
fig. 3
X
NOT ALWAYS
fig. 4
INSTALLER
A
E
A
X X
Y
6,5
15 23
Z
B
C
A
D
B
C1
C
B
C
C1
X
X
15 6,5
X