Table of Contents
Advertisement
Switching Movie Quality Mode.
You can switch the movie quality between "FINE" and "STND".
However, record critical subjects in the "FINE" mode.
Block-like noise may appear in recorded image, or the outline of subject image is
distored under the recording conditions listed below: Pan the camcorder as slowly as
possible. (Block noise is likely to appear in the "STND" mode):
•
If there is a complicated pattern (trees, fence, etc.) in background (as in following
figure on left)
•
If the camcorder is panned or tilted greatly or rapidly
•
If subject is moving rapidly even when the camcorder is not moving
(Image when block-like noise occurs)
1. Press the MENU button in the recording pause status to display the
menu screen.
2. Use the Select dial to choose "REC
SETUP" and then "V.QUALLTY".
Options will be next to V. QUALITY: "FINE" is be-
ing highlighted.
3. Turn the Select dial to highlight "STND",
and then press the Select dial.
The menu screen for setting record mode will be
restored, and "STND" has been specified.
4. Press the MENU button to switch off the menu screen.
Useful Functions during Recording of Movie
(Image without block-like noise)
77
Advertisement
Table of Contents
