Table of Contents
Advertisement
chapter 2_Setups
Cautions
• During and after charging, the battery will be warm, but this does not indicate a fault.
• If the POWER indicator on AC adapter/charger blinks, remove the battery once, and then reattach it. If
the POWER indicator still blinks, the battery may be faulty.
• If the ambient temperature is a little too high or low, the CHG. indicator or CHG.80 indicator on AC
adapter/charger will blink at 6-second intervals. In this case, charging is possible, but it will take
longer than usual.
• If the ambient temperature is too low or too high, the CHG. indicator or CHG.80 indicator on AC
adapter/charger will blink at one-second intervals, showing that charging will not be possible.
Attaching Battery to DVD Camcorder
Caution
• Make sure that the battery is securely attached: Incomplete attachment could cause the battery to fall,
resulting in damage.
1. Pull out the viewfinder fully and raise it.
2. Align the top of battery with the top sur-
face of battery attachment platform of
DVD camcorder.
3. While fitting the battery onto the DVD
camcorder, slide it downward until a
click is heard.
Removing Battery
After using the DVD camcorder, remove the battery from it.
Cautions
• For safety, be sure to turn the DVD camcorder off before attaching or removing the battery.
• If the battery remains attached, minute level current will flow even if the DVD camcorder is off, and
the battery will discharge.
42
1
2 · 3
Advertisement
Table of Contents
