Hi-Touch Imaging Technologies Mug Heat Press Kit User Manual page 22

Mug heat press kit
Table of Contents

Advertisement

4-2. Teflon Replacement
// The white Teflon on the surface of the heater plate is used for improving the image
transferring effect onto the mug. If you find any cracks on the surface of the Teflon, please
contact your local distributor and replace the Teflon according to the following procedure. //
1. Take out the cracked Teflon.
2. Use new Teflon, and fold the two sides along the folding lines. (The folding
lines should be vertical to each other as the following illustration.)
Two mark for both side
3. Put the Teflon inside the mug heat press as illustrated below.
Put it onto the Mug Heat Press
4. Wrap up the U part on both sides of the white Teflon to cover the white slicon,
the orange heater plate, and the black rubber as illustrated below.

Advertisement

Table of Contents
loading

This manual is also suitable for:

116n

Table of Contents