Table of Contents
Advertisement
Useful Tips:
(1). Carefully cutting off excessive margin on top of photography
(2). Place mug inside locating coil.The bottom of the mug should be in parallel with locating coil
(3). Left and right side of photograph should be in parallel with the edge of locating coil
(4). Avoid any gap between mug and photography
4. Wrap the Dye Sublimation Photography on the mug with the image facing
the mug and the bottom of photography is just above the mug locating coil
5. Use mug locating tape to secure the photo onto the mug's surface.
Useful Tips:
(1).
Remain the opposite position between photo and Mug surface, before sticking the tape
(2). Remove locating coil after photograph is firmly taped on mug
6. Place the mug up side down on the Bubble Eliminator with the mug holder
facing outward
7. Push the adjustor to tighten the mug aginst the plastic roller. With hand
holding the mug holder, rotating the mug counter-clockwise to squeeze any
air between the mug and the photo.
Advertisement
Table of Contents
