Table of Contents
Advertisement
14. Push the adjustor to tight on the mug against the plastic roller. With hand
holding the mug holder, rotate the mug counter-clockwise and clockwise to
squeeze any air between the mug and the photo.
Useful Tips:
(1). Start to bubble elimination process immediately after pre-heating process in order to have
the best result
(2). Start from the center of the photography to eliminate the bubble. Rotate clockwise and
counter-clockwise 5 times
(3). Please wear a pair of glove to avoid burning
15. Hold on the mug holder and release the adjustor. Remove the mug from the
Bubble Eliminator.
16. Place the mug in Mug Heat Press wrapper. Hold on the mug holder and
tighten the space between mug and the wrapper. Press "OK" button to
continue the heating process again
Useful Tips:
(1). Due to silicon is been heating and it will increase the pressure to hold down the lever.
Please lose the lever knot to release the pressure.
(2). Press and hold down the lever to ensure the imprint quality
17. When heating process is completed, machine automatically stops. Press
"OK" button to stop the alert tones, hold on the mug holder, and take out the
mug from wrapper with extreme care.
<CAUTION! DO NOT TOUCH THE SURFACE OF MUG. IT IS EXTREMELY
HOT>
X
Advertisement
Table of Contents
