Table of Contents
Advertisement
Quick Links
PLOW MOUNT KIT
FOR STAMPEDE AND HAVOC
P/N 34-8030
ASSEMBLY / OWNERS MANUAL
Application
PLOW PUSH FRAME NO. 34-0000 or 34-0070
Before you begin, please read these instructions and check to be sure all parts and tools are ac-
counted for. The following instructions contain details required to install and service the contents of
this kit.
© 2018 Kolpin Outdoors Inc.
REV 00
Advertisement
Table of Contents
Related Manuals for Kolpin Outdoors 34-8030
Summary of Contents for Kolpin Outdoors 34-8030
- Page 1 Before you begin, please read these instructions and check to be sure all parts and tools are ac- counted for. The following instructions contain details required to install and service the contents of this kit. © 2018 Kolpin Outdoors Inc. REV 00...
- Page 2 IN UP POSITION. DO NOT ATTEMPT TO RAISE BLADE BY HAND; USE THE LIFT MECHANISM ONLY. LOWER BLADE TO DOWN POSITION WHEN BLADE AND ATV/UTV ARE NOT IN USE. READ BLADE'S INSTRUCTION SHEETS AND ATV/UTV OWNER MANUAL. © 2018 Kolpin Outdoors Inc. REV 00...
- Page 3 Carriage Bolt, Zinc Plated, M8-1.25 x 30mm LG Flanged Lock Nut, Zinc Plated M8 x 1.25 Flat Washer, Zinc Plated, M10 Carriage Bolt, Zinc Plated, M8-1.25 x 25mm LG Instruction Guide (not shown) © 2018 Kolpin Outdoors Inc. REV 00...
- Page 4 Spare kits may contain extra hardware that is used for other mount kits. Extra hardware can be discarded. • U-bolts supplied in spare kits may be longer than original and may need to be cut to size. • © 2018 Kolpin Outdoors Inc. REV 00...
- Page 5 (item #2) and thru the front hole in the chassis as shown. (See illustration 1-2). Insert Item #2 through the hole in the bottom of the chassis Ill. 1-2 Item #2 shown in position © 2018 Kolpin Outdoors Inc. REV 00...
- Page 6 (item #3) and thru the vehicle frame holes as shown. Fasten with M8 lock nuts (item #6). (See illustrations 1-3 and 1-4). 5. Tighten all hardware to specification. 8MM FASTENER TORQUE: 17 ft. lbs. (23 Nm) Ill. 1-4 © 2018 Kolpin Outdoors Inc. REV 00...
- Page 7 M8 locknuts (item #6). (See illustration 1-5). 7. Tighten all hardware to specification. Universal Mount Plate (not included) mounting location 8MM FASTENER TORQUE: 17 ft. lbs. (23 Nm) FRONT Ill. 1-6 FRONT © 2018 Kolpin Outdoors Inc. REV 00...
- Page 8 Most hardware is general in nature and is easily obtained locally. Be sure to replace with minimum metric class 8.8 specification. Kolpin Outdoors, Inc. Telephone: (763)-478-5800 Toll Free: (877)-956-5746 Fax Number: (800)-245-7569 www.kolpin.com Email: customerservice@kolpin.com © 2018 Kolpin Outdoors Inc. REV 00...
Need help?
Do you have a question about the 34-8030 and is the answer not in the manual?
Questions and answers