IKEA SMAKSAK Manual page 66

ENGLISH
Problem
The display shows "C2".
The display shows "C3".
The display shows "F102".
The display shows an error
code that is not in this table.
There is no good cooking
performance using the func-
tion: Direct Steam.
There is no good cooking
performance using the func-
tion: Direct Steam.
The water in the cavity em-
bossment does not boil.
Possible cause
You want to start the Pyroly-
sis or Defrost function, but
you did not remove the core
temperature sensor plug
from the socket.
The cleaning function does
not operate. You did not
fully close the door, or the
door lock is defective.
• You did not fully close the
door.
• The door lock is defective.
There is an electrical fault.
You did not turn on the func-
tion: Direct Steam.
You did not fill the cavity
embossment with water.
The temperature is too low.
Remedy
Remove the core tempera-
ture sensor plug from the
socket.
Fully close the door.
• Fully close the door.
• Deactivate the oven with
the house fuse or the
safety switch in the fuse
box and activate it again.
• If the display shows
"F102" again, contact an
Authorised Service Cen-
tre.
• Deactivate the oven with
the house fuse or the
safety switch in the fuse
box and activate it again.
• If the display shows the
error code again, contact
an Authorised Service
Centre.
Refer to "Activating the func-
tion: Direct Steam".
Refer to "Activating the func-
tion: Direct Steam".
Set the temperature at least
to 110 °C.
66