IKEA SMAKSAK Manual page 63

ENGLISH
2. When the display shows P1, press
start the procedure.
You can use the End function to delay
the start of the cleaning.
During the Pyrolysis the oven lamp is off.
Time of the procedure:1 h 30 min.
3. When the oven is at the set
temperature, the door locks. The display
shows
Do not open the door before the
procedure completes. This will
abort the procedure. When the
oven cools down, the door
automatically unlocks.
4. When Pyrolysis is completed, the
display shows the time of day. The oven
door stays locked. When the oven is
cool again, the signal sounds and the
door unlocks.
To stop Pyrolysis before it is
completed, turn the knob for the
oven functions to the off position.
Cleaning reminder
To remind you that the pyrolysis is
necessary, PYR flashes in the display for 10
seconds after each activation and
deactivation of the oven.
The cleaning reminder goes
out:
• after the end of the pyrolysis.
• if you press
same time while PYR flashes in
the display.
Removing and installing door
The oven door has three glass panels. You
can remove the oven door and the internal
glass panels to clean them. Read the whole
"Removing and installing door" instruction
before you remove the glass panels.
to
and at the
The oven door may close if you
try to remove the glass panels
before you remove the oven
door.
Caution! Do not use the oven
without the glass panels.
1. Open the door fully and hold both
hinges.
2. Lift and turn the levers fully on both
hinges.
3. Close the oven door halfway to the first
opening position. Then lift and pull
forward and remove the door from its
seat.
4. Put the door on a soft cloth on a stable
surface.
5. Hold the door trim (B) on the top edge
of the door at the two sides and push
inwards to release the clip seal.
63