Solid State Logic THE BUS+ User Manual page 39

CAUTION!
This equipment must be Earthed. Refer to the manual for installation instructions. Disconnect all power
sources before removing any panels. No user-serviceable parts inside - to be serviced only by qualified
personnel.
WARNING!
Un-earthed metal parts may be present inside the enclosure. Check for hazardous voltages before touching.
RoHS notice
Solid State Logic has conformed and this product has conformed to European Union's Directive 2011/65/EU on Restrictions of
Hazardous Substances (RoHS) as well as the following sections of California law which refer to RoHS, namely sections 25214.10,
25214.10.2, and 58012, Health and Safety Code; Section 42475.2, Public Resources Code.
Instructions for disposal of WEEE by users in the European Union
The symbol shown here, which is on the product or on its packaging, indicates that this product must not
be disposed of with other waste. Instead, it is the user's responsibility to dispose of their waste equipment
by handing it over to a designated collection point for recycling of waste electrical and electronic
equipment. The separate collection and recycling of your waste equipment at the time of disposal will help
to conserve natural resources and ensure that it is recycled in a manner that protects human health and
the environment. For more information about where you can drop off your waste equipment for recycling,
please contact your local city office, your household waste disposal service or where you purchased the
product.
FCC Certification
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
For USA – to the user
• Do not modify this unit! This product, when installed as indicated in the instructions contained in the installation manual,
meets FCC requirements.
• Important: This product satisfies FCC regulations when high quality shielded cables are used to connect with other equipment.
Failure to use high quality shielded cables or to follow the installation instructions may cause magnetic interference with
appliances such as radios and televisions and will void your FCC authorisation to use this product in the USA.
• Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment
is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required
to correct the interference at his own expense.
THE BUS+ User Guide
UKCA & EU Compliance
This product complies with the following European Union Harmonisation Legislation:
Electromagnetic Compatibility directive (EMC) 2014/30/EU.
Low Voltage directive (LVD) 2014/35/EU.
Appendices
39