MATTRESS FIRM POWER BASE 900 Owner's Manual page 12

Remote Control Guide
Pairing your remote control to your adjustable bed Pairing your remote control to your adjustable bed
Your adjustable bed is already paired to your remote control at the factory. Manual pairing is only needed for
replacement remote controls.
NOTE: For the pairing to be successful, make sure the distance between the control box and the remote control is not
more than 2 meters.
1
Unplug the power cord from the electrical outlet. If installed,
remove the two (2) 9V alkaline batteries intended for back-up
battery power.
2
Plug the power cord back to a working electrical outlet. A surge
protector is recommended. The LED light on the control box
turns blue and the control box is in remote pairing mode for 20
seconds.
3
On your remote control, press and hold the Flat and massage
Stop buttons for 4 seconds.
If the pairing is successful, the LED light on the control box turns
green immediately. If pairing fails, the LED light on the control
box stays blue and turns gree only after the 20-second timeout.
Repeat steps 1 to 3 until pairing is succesful.
Synchronizing two beds for tandem operation Synchronizing two beds for tandem operation
To operate two adjustable beds simultaneously, you must connect both best using a sync cable.
1
Plug both Bed A and Bed B to working electrical outlets. A surge
protector is recommended.
2
Before starting the sync process, make sure Bed A and Bed B are
in a flat position. Press the
B to align the beds properly.
3
Plug one end of the sync cable to the control box on Bed A.
Insert it into the port labeled SYNC.
Plug the other end of the sync cable to the control box on Bed B.
Insert it into the port labeled SYNC.
Beds A and B can now be controlled by both remote controls at
any given time.
NOTE: When doing a tandem operation, make sure both Bed A
and Bed B are plugged into a working electrical oulets.
12
Flat button on Remote A and Remote