Disassembly - Pride Mobility JET 3 Owner's Manual

SEAT REMOVAL
You may wish to remove the seat to transport your Jet 3.
WARNING ! Do not pick up the seat frame by the armrests. They are free to pivot, and you may lose
control of the seat if they do so, resulting in personal injury or damage to the chair.
To remove the seat:
1. Turn the power off.
2. Make sure the Jet 3 is not in freewheel mode.
3. Unplug the main wiring harness behind the seat.
4. Lift the seat up and out of the seat tower.
BODY SHROUD REMOVAL
The body shroud is a one-piece molded plastic body that covers the power base frame. You must remove the
body shroud in order to change the batteries and check the cable connections.
To remove the body shroud:
1. Turn the power off.
2. Make sure the Jet 3’s motors are engaged. See IV. “The Jet 3.”
3. Unplug the controller wiring harness.
4. Pull lever and turn the seat slightly while lifting.
5. Remove the seat.
6. Lift the body shroud straight up. It should lift up easily.
BATTERY REMOVAL
To remove the batteries, see VII. “Batteries and Charging.”
Jet 3/Rev I/Feb03
All manuals and user guides at all-guides.com
V I . D I S A S S E M B L Y
www.pridemobility.com 25