V I I I . D I S A S S E M B L Y A N D A S S E M B L Y; Disassembly - Pride Mobility Victory Series Manual

V I I I . D I S A S S E M B L Y A N D A S S E M B L Y

DISASSEMBLY

No tools are required to disassembly or assemble your Scooter. Always choose a level, dry surface with sufficient
room for you to work and move around—approximately 1.5 meters in all directions. Keep in mind that the
disassembled sections of the Scooter take up more floor space than the assembled unit. You may need assistance
to lift some of the Scooter components; see III. “Specifications” for individual component weights.
WARNING! Lifting weight above your capacity could result in personal injury.
NOTE: Place the manual freewheel lever in the drive (down) position before disassembly.
1. Remove the key from the key switch.
2. Remove the seat from your Scooter. Unlock the seat using the seat lock lever, turn the seat a quarter turn, and
then lift the seat.
3. Remove the rear shroud by detaching it from the reusable fasteners holding it in place.
4. Unplug the large, white, 9-pin front-to-rear connector that connects the control console assembly to the
electronic controller module. See figures 20 and 20a.
5. Unplug both 2-pin battery harnesses. See figures 20 and 20a.
6. Unfasten the battery tie-down strap, then lift both batteries from the battery wells.
CAUTION! Failing to unplug the front-to-rear connector and both battery harnesses prior to further
disassembly could result in permanent damage to your Scooter.
UNPLUG FRONT-TO-REAR CONNECTOR
Figure 20. Victory 3 and 4 Wheel Cable Connections
Victory
UNPLUG BATTERY HARNESSES
UNPLUG BATTERY HARNESSES
Figure 20a. Victory XL and XL-8 Cable Connections
UNPLUG FRONT-TO-REAR CONNECTOR
31