SECTION 4: ASSEMBLY
Beginning Assembly
Assembly of the G1028/G1029 is straightforward.
We have organized the assembly process into
steps. Please follow them in sequence.
Caution: All die-cut metal parts have a sharp
edge (called "flashing") on them after they are
formed. This is removed at the factory.
Sometimes though, a bit of flashing might escape
inspection. Please examine the edges of all die-
cut metal parts before handling them.
Tools Required: 12mm open end wrench, regu-
lar and Phillips head screwdriver.
G1028/G1029 Dust Collector
Base
Position the base plate upside down and locate
the casters so they are within easy reach. Mount
the casters to the base plate using sixteen
18 x
1
⁄
" hex bolts provided. Figure 3.
2
Figure 3. Mounting casters to base.
5
⁄
" -
16
-9-