Replacing A Gpu Module; Guidelines - H3C UniServer R4300 G5 User Manual

Figure 90 Installing the flash card
3. Install the standard storage controller on the riser card. For more information, see
riser card and a PCIe
4. Install the riser card on the server. For more information, see
module."
5. Connect the cables for the standard storage controller to the drive backplane. For more
information, see
6. If a supercapacitor is installed, connect the supercapacitor extension cable to the flash card.
For more information, see
7. Install the access panel. For more information, see
8. Rack-mount the server. For more information, see
9. Connect the power cord. For more information, see
10. Power on the server. For more information, see

Replacing a GPU module

Guidelines

When you install single-width HHHL GPUs, use
and guidelines:
•
You can install a maximum of 6 GPUs.
•
You must install the GPUs in x16 PCIe slots.
•
Make sure each fan slot is installed with a FAN-H-4UG5 high-performance fan module.
module."
"Connecting internal cables."
"Connecting supercapacitor extension
82
".Installing a riser card and a PCIe
"Installing the access
"Rack-mounting the
"Connecting the power
"Powering on the
Table 10 to select slots and follow these restrictions
".Installing a
cables."
panel."
server."
cord."
server."