Table of Contents
Advertisement
Inspecting the Machine
Checking the Traction Unit
Requirements
Use the following list as a reference:
•
Refer to
Specifications (page 7)
horse power and minimum lifting capacity for the
traction unit.
•
The traction unit must have a drawbar hitch.
•
Adequate front-end weight (ballast) to offset the
weight of the machine.
•
Check the tire air pressure of the traction unit.
Adjust the tire air pressure as needed.
Important:
Do not exceed the maximum
or minimum tire inflation pressures as
recommended by the tire manufacturer.
Checking the Ballast
Requirements
WARNING
Mounting the machine to the rear of the
traction unit decreases the weight on its front
axle.
Failure to add required ballast may result in
an accident and severe injury or death.
• To ensure adequate steering control and
stability you may need to add ballast to the
front of the traction unit.
• Refer to the traction unit operator's manual
for ballast requirements.
Product Overview
Controls
Brush switch
for the minimum
Use the switch to raise and lower the brushes.
Important:
from both ends of each brush before raising and
lowering the brushes (see
to the highest position beneath the brushes.
6
Remove the hairpin cotter and pin
Figure
Figure 6
10). Install them
g347549
Advertisement
Table of Contents
