Electrolux TE1220E Installation Manual page 32

32
14. Sign and date one of the STICKER B (Conversion Record) and apply it on the right side panel adjacent to the
gas valve.
15. Reinstall the lower panel.
H Apply STICKER B Here
Leak Check
1. Turn on gas supply.
2. Plug in dryer or reconnect power.
3. Set dryer cycle to time high heat and turn on dryer.
4. Brush or spray an approved noncorrosive leak-detection solution onto pressure tap and union nut (if applicable)
and inspect for leaks indicated by growing bubbles.
5. If any bubbles are present, turn off gas supply, tighten the leaking connection and retest for leaks.
6. If dryer was moved during conversion, use the same method to check for leaks in the flexible gas supply line and
fittings between the dryer and the gas supply pipe.
7. If any bubbles are present, tighten the leaking connection and retest for leaks.
8. Unplug dryer or disconnect power.
Installation manual
fig.W01630