Table of Contents
Advertisement
WOODEN WINE RACK TRIM FINISHING
All wine racks come with an unfinished solid hardwood face, which can
be removed and replaced with other wood to match the surrounding
cabinetry.
The included unfinished faces can be finished and sealed. In many
cases, stains and/or finishes have odors that may be objectionable in
an enclosed area. To remove the front wood face from the wine shelf,
simply pull out the wine shelf and remove the fasteners. Finish as
desired and re-install with original fasteners.
OPERATION
General
The unit is equipped with a state-of-the-art refrigeration system and
is a frost-free model. The evaporator coil automatically defrosts on
demand at predetermined intervals.
Interior Light
The unit is equipped with an interior light that illuminates when the
door is opened. A manual switch is located next to light for displaying
the product through a glass door. Always ensure the manual switch is
in the off position before closing a solid wood or stainless steel door. If
manual switch is left on for an extended period of time, it may increase
the cabinet temperature, especially at the top, and cause the refrigera-
tion system to run longer.
Loading Product
IMPORTANT: Before storing perishables, allow unit to run for a mini-
mum of 24 hours to allow temperature stabilization after start-up.
5
"
/
8
1
1
"
/
2
14
1
" x 0.312" deep
/
8
8"
5
"
/
16
5
18
"
/
16
Figure 10. Wooden Wine Rack Trim
24" ADA-Compliant Series Operation / Installation Manual
When loading items into unit, do not block internal louvers and fan
guard openings or performance will be decreased.
Temperature Control
The controller is located at the top rear panel of the cabinet (Figure
11). Approximate temperature operating ranges are:
Refrigerator:
Wine Reserve:
Beverage Center: 36°F minimum, 48° maximum
A
T
DJUSTING
EMPERATURE
• Colder Temperatures: Turn the adjusting screw clockwise (to the
right).
• Warmer Temperatures: Turn the adjusting screw counterclockwise
(to the left).
• Temperature Control "OFF": Turn the adjusting screw completely
counterclockwise to the "OFF" position until a click is heard.
The condenser fan and motor turns off and on with the compressor.
Checking Product Temperature
To accurately check the temperature of the product stored in a refrig-
erated compartment, insert an accurate thermometer into a sealable
plastic (non-breakable) bottle, partially filled with water. Tighten the
cap securely.
7
1
"
1
17
"
/
/
4
32
33°F minimum, 39° maximum
40°F minimum, 65° maximum
1
"
/
2
1
" to
1
"
/
/
16
8
radius all
outside edges
© 2009
Advertisement
Table of Contents
