NOTE:
Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in
Before working inside your
working inside your
computer. For more safety best practices, see the Regulatory Compliance home page at
regulatory_compliance.
Prerequisites
1. Remove the battery.
2. Remove the
optical
drive.
3. Remove the keyboard.
Procedure
1. Close the display, and turn the computer over.
2. Remove the eight screws (M2.5x8) that secure the base cover to the palm-rest assembly.
3. Remove the two screws (M2x5) that secure the base cover to the palm-rest assembly.
4. Remove the three screws (M2x2) that secure the base cover to the palm-rest assembly.
5. Turn the computer over, and open the display.
6. Remove the three screws (M2x5) that secure the base cover to the palm-rest assembly.
7. Open the latch, and disconnect the optical-drive cable from the system board.
Removing the base cover
computer. After working inside your computer, follow the instructions in
After
www.dell.com/
Removing the base cover
9
19