Table of Contents
Advertisement
H27i
F INSPECT FIVE (5) DRIVE BELTS
Engine/PTO (3), Ground Drive (1) and Deck
Drive (1).
F CHECK FUNCTIONS OF WARNING LIGHTS
AND WARNING HORN
Turn the ignition key to the ON (RUN) position.
Oil Pressure Warning Light, Engine Service
Light, and Warning Horn should all operate,
indicating normal function.
F CHECK FUNCTION OF SAFETY INTERLOCK
SWITCHES
Refer to Safety Switch System on page 63
to check for proper operation of safety switch-
es, both during engine starting and with the
operator leaving the seat with tractor moving
forward or with the mower blades en gaged.
F CHECK TIRE PRESSURE
Deck Caster Wheel = 20 PSI (137 kPa)
Drive
Tailwheel
F CHECK DECK IS SECURELY ATTACHED
Check for correct deck attachment (lynch pins
and counterweight springs).
F CHECK SECURITY OF DRIVE TIRE MOUNT-
ING NUTS
The eight (8) Drive Tire mounting nuts should
each be torqued to 75 to 85 lb·ft (102 to 115
N·m).
F ADJUST MOWER CUTTING HEIGHT, IF
REQUIRED
Refer to Adjusting Cutting Height on page
40.
F CHECK AND CLEAN GRASS BUILDUP
UNDERNEATH MOWER DECK
Refer to cleaning Grass Buildup in Mower
Deck Housing on page 57 for deck tilt-up
and deck cleaning information.
= 15 PSI (103 kPa)
= 20 PSI (137 kPa)
DANGER
Never operate cutter blades with deck in
raised position because it is hazardous.
The tilt-up deck is secured in the raised posi-
tion using the following procedure:
1.
Remove the tilt bar from the stowed position
on the carrier frame.
2.
Use the tilt bar to release the two (2) deck
locking arms as shown in the Unlock Deck
Arms for Deck Tilt-Up illustration.
Unlock Deck Arms for Deck Tilt-Up
3.
Fit tilt bar into the socket on front of deck
housing and secure with hitch pin.
4.
Remove footrest or, if equipped with adjust-
able footrests, move the footrest to the full
forward locking position.
5.
Raise deck to tilt-up position using tilt bar and
secure in position by inserting the deck hook
in the tilt-up latch on the tractor body as shown
in the Deck Secured in TILT-UP Position
photo. Before operating the mower, make
sure to re-engage the locking arms into the
LOCKED position after lowering the deck to
the normal operating position.
Assembly Instructions
Tilt Bar
25
Advertisement
Table of Contents
