Table of Contents
Advertisement
H27i
SAFETY, CONTROL, AND INSTRUCTION DECALS
if any are missing, illegible, or damaged, a replacement should be ordered and installed before
putting the machine into operation. The Decal Part Number is listed below and in the Parts Manual.
1.
Location: Left Fender
Part Number: 2802-5
Location: Underside of Rear Body
Part Number: 2107-5
1.
Ground drive belt routing.
2.
PTO clutch belt routing.
Safety, Control, and Instruction Decals are installed on the machine;
1.
2.
3.
4.
2.
<15°
5.
6.
7.
8.
2802-5
1.
2.
1.
Throttle
●
Move lever forward to increase engine
speed; back to idle.
2.
Warning – read Operator's Manual before
operating the machine.
3.
Warning – wear eye and ear protection when
operating the machine.
4.
Warning – read Operator's Manual before
servicing or performing maintenance.
●
Engage parking brake.
●
Remove ignition key.
5.
Warning – roll-over hazard.
●
Do not operate on slopes greater than 15
degrees.
6.
Warning – thrown object hazard.
●
Keep bystanders away from the machine
when operating.
7.
Warning – entanglement hazard.
●
Keep all guards in place while engine is
running.
8.
Parking Brake
●
Move lever forward to engage Parking
Brake; back to disengage.
Location: Deck Height Adjuster
Part Number: 2748-2
Move pin to desired height of cut.
Location: Adjacent to Oil Cooler
Part Number: 6895-103
Change engine oil and oil filter every 300 hours.
Safety Instructions
17
Advertisement
Table of Contents
